Capabilities and Service Line Card
A clear overview of our capabilities in machining, welding, fabrication, and materials.
Angeles Machine Works Inc.
404 East Second Street – P.O. Box 765
Port Angeles, WA 98362
Phone – (360) 457-0011 ~ Fax – 360-457-0012
Emergency – (360) 808-3232
www.angelesmachineworks.com
Angeles Machine Works has served the North Olympic Peninsula since 1968 with general machine work and fabrication which includes, but not limited to, the following:
Hydraulic Cylinder (mfg & repair)
Air Compressors (rebuild)
Air Cylinder (mfg & repair)
Sprockets, Gears – bored & keyed
Shafts, Keyed also Portable Key Seats
Mill Heads, Manifolds, & Face Flywheels
Driveline – repair & mfg new
Kingpins, Bushing, & Honing
Mfg Flame Cut Conveyor Mill Chain Sprockets all sizes from 78 pitch to 132 pitch
Steel, Stainless Steel & Aluminum Fabrication
Marine/boat shafts – up to 3½” diameter
Gear Box repair
Electric motor shafts and repair
Metal spraying, shaft journal repair
Irrigation pump rebuild
Farm equipment repair
Motor mounts, gearbox base plates
Brackets
Babbitt bearing mfg & repair
A large variety of R and D work
Lathe: Ten lathes – range in size from 40” swing x 10 ft. in length on down.
Some with digital readout.
Standard and metric threading.
Milling Machines: A variety of Horizontal and Vertical with digital readout.
Welding: Arc Welding, Mig Welding, Tig Welding (Steel, Aluminum, Magnesium & Stainless Steel)
Flame Cut and/or Plasma Cut with electric eye, which will cut up to four-foot square and up to eight-inch thick steel and 1½ inch thick Stainless Steel.
Accuracy of +/- .010 of an inch of drawing.
Brazing of cast-iron and similar metals.
Portable Welding & Torch Work
Bore Welder and Boring Bars: Capable of a variety of setups in the shop and portable.
Materials in Stock: Standard shafting up to 3 15/16 in mill sizes and up to 3½ inch in pin sizes
Both Cold Roll and 4140 TGP, along with a good selection in Hot Roll, along with Chrome Piston Rod material.
D.O.M. Tubing.
Flat Bar, Angle Iron, Channel Iron, Black Iron Pipe in a variety of sizes.
Plate Steel from 16 gauge to 3 inch thick in mild steel and T-1 plate.
Stainless Steel and Aluminum
Plastics in a variety of materials, rods, tubes, and plates.
Angeles Machine Works Inc. strives to give the customer the highest quality of work at a fare cost.